Creative PC-CAM 350 - Problem Installing Software; Problems Using PC-CAM 350

Troubleshooting B-1
Troubleshooting
This appendix provides solutions to problems you may encounter during installation
or normal use.
Problem
Installing
Software
The setup program for PC-CAM 350 does not run automatically after you insert the
Installation CD into the drive.
The AutoPlay feature in your Windows system may not be enabled.
To install the software from the CD:
1. Leave the installation CD in the CD-ROM drive.
2. Click Start -> Run.
3. In the Open box, type D:\CTRUN\CTRUN.EXE (where D: represents your CD-
ROM drive).
4. Follow the instructions on the screen to complete the installation.
Problems Using
PC-CAM 350
There is no USB port available to connect the USB cable.
Do one of the following:
❑ Unplug the device currently connected to the USB port.
❑ Add a self-powered USB hub.
❑ Add a PCI USB card.