Figure 2. Soundfont Control dialog box where you configure MIDI banks.
To configure a MIDI bank:
In SoundFont Control, click the Configure Bank tab.1.
In the Select Bank list, select the MIDI bank to configure.2.
Click the Load button and load the SoundFont file you want to the MIDI bank. The latest
file loaded always appears at the top of the Bank Stack box. The top of the stack is
indicated by an arrow.
3.
To replace a SoundFont file, click the file and then click the Replace button.
OR
Double-click the file, and select the replacement.
4.
To clear a bank from the stack, select the bank and then click the Clear button. A
variation bank can only be cleared by clearing its main bank.
5.
Repeat Steps 3, 4 or 5 as required.6.
By stacking a SoundFont file instead of replacing one with the other, you may return to the
original sounds or use the new selection.
To Next Page
Loading...
Need help?
General
