Troubleshooting and FAQs B-7
• obtaining the most current BIOS for your motherboard from the
manufacturer’s web site*.
*Content in these web sites is controlled by other companies. Creative bears no
responsibility for information or downloads obtained from them. This information is
provided only as a convenience to you.
Insufficient
SoundFont
Cache
There is insufficient memory to load SoundFont banks.
This may occur when a SoundFont-compatible MIDI file is loaded or played while
insufficient memory has been allocated to Creative SoundFont Bank Manager.
To have sufficient SoundFont cache memory:
❑
Remove one or more SoundFont banks from your SoundFont cache.
Do the following:
i. Click the
Bank
button.
The Configure Bank dialog box appears.
ii. Click the
Select Bank
drop-down button, and select a bank index.
iii. Highlight the bank and click the Remove button.
iv. Click the
OK
button to finish configuring your banks.
❑
Load smaller SoundFont banks instead; or add more RAM to your system.
Do one of the following:
•In the
Configure Bank
dialog box of Creative SoundFont Bank Manager,
select a smaller SoundFont bank, if available, from the
Select Bank
box.
• Increase the system RAM on your computer. For more details, visit the
www.soundblaster.com site for technical help.
Note: The amount of SoundFont cache you can allocate depends on the system RAM
available. Your computer may slow down if the amount of cache used is too high.
The trade-off of a smaller
SoundFont file is its lower
sound quality.
To Next Page
Loading...
