IMPORTANT WARNINGS!
DO NOT SWITCH THE APPLIANCE ON IF YOU SUSPECT IT OF BEING FROZEN.
WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT.
DO NOT OPERATE THE APPLIANCE IF WATER DISCHARGES FROM THE PRESSURE RELIEF
VALVE. MAINTENANCE IS REQUIRED BEFORE THE APPLIANCE CAN BE SAFELY USED.
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN AND
THE INFIRM) WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES,
OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION
OR INSTRUCTION CONCERNING USE OF THE APPLIANCE
BY A PERSON RESPONSIBLE FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY
DO NOT PLAY WITH THE APPLIANCE.
1. Ensure the electricity and water are turned on to the unit.
2. Press the start / stop button “B”.
This will turn the shower on, the water will flow and the
indicator lights will glow showing chosen Power Selection.
We recommended you do not enter the water spray during
this period, especially if the shower has just been used.
Knob “A” controls the power selection.
Select “FULL HEAT ”, “HALF HEAT ” or “COLD ”.
The most popular is “FULL HEAT” and for your
convenience this can be obtained in two positions
so you are always only one step away from maximum power
3. If the water is not at your desired showering temperature,
turn knob “C” a small amount until you reach the
desired showering temperature.
Turn clockwise for cooler.
Turn anti-clockwise for warmer.
4. When you have finished showering, press the start / stop button “B” again.
The indicator lights will go out.
5. Wait for the water to stop, switch off the electricity supply at the ceiling switch or local isolator.
Notes
Wait 20 seconds for the temperature to stabilise after each adjustment.
The indicator lights illuminate when the heaters are on and, if the shower has been
recently used, they may take up to 20 seconds to come on.
During this time the water may go from very hot to cold before stabilising.
The position of knob “C” will be approximately the same each time the shower is
used, varying only with incoming water temperature or pressure changes
(e.g. you will only need to change from summer to winter).
During normal operation, if an overheated water temperature is sensed then the
heater will switch off and the “overheat” light will illuminate.
Water will continue to flow and cool down before the heater switches back on again.
We offer a technical advisory service on the telephone:- CALL 0844 372 7766 (UK ONLY)
Or alternatively email us at:- Service.request@redringxpelair.com
To Previous Page
Loading...
