Crem EX3 MINI 1GR - Tou - Boiler Filling Time-Out; Cle - Automatic Group Cleaning Cycles; Prd - Enabling;Disabling Dose Programming; Sen - Level Probe Sensitivity

10
· toU – Boiler lling Time-out
To change the boiler lling time-out, follow the steps below:
1. Enter the service programming and browse through the menu (see previous instructions).
2. When [toU] is shown on the display, enter by pressing K5.
3. Select with K1 and K2 the boiler lling time-out in seconds.
4. Accept and save setting by pressing K5. You are back in the service programming menu.
SERVICE PROGRAMMING
· cLE – Automatic group cleaning cycles
To change the automatic group cleaning program cycles, follow the steps below:
1. Enter the service programming and browse through the menu (see previous instructions).
2. When [cLE] is shown on the display, enter by pressing K5.
3. Select with K1 and K2 the automatic group cleaning cycles.
4. Accept and save setting by pressing K5. You are back in the service programming menu.
· Prd – Enabling/Disabling dose Programming
To enable or disable the dose programming function, follow the steps below:
1. Enter the service programming and browse through the menu (see previous instructions).
2. When [Prd] is shown on the display, enter by pressing K5.
3. Use K1 and K2 to enable [on] or disable [oFF] the Dose programming function.
4. Accept and save setting by pressing K5. You are back in the service programming menu.
· SEn – Level probe sensitivity
To change the level probe sensitivity, follow the steps below:
1. Enter the service programming and browse through the menu (see previous instructions).
2. When [SEn] is shown on the display, enter by pressing K5.
3. Select with K1 and K2 the Level probe sensitivity between: [L] Low; [M] Medium; [h] High.
4. Accept and save setting by pressing K5. You are back in the service programming menu.