EasyManua.ls Logo

Crem EX3 MINI 1GR - SLA - Service Liter Alarm (Water Filter Maintenance); Sca - Service Coffee Alarm (Maintenance); Tu - Temperature Units; Skp - Ski - Skd - PID Parameters Kp, Ki & Kd

Default Icon
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
· SLA – Service liter alarm (Water lter maintenance)
To change the Service liter alarm, follow the steps below:
1. Enter the service programming and browse through the menu (see previous instructions).
2. When [SLA] is shown on the display, enter by pressing K5.
3. Select with K1 and K2 the Service lter alarm value. The counter can be adjusted in steps of
10L = [001]: From [000] = 0L = Disabled, to [999] = 9990L.
4. Accept and save setting by pressing K5. You are back in the service programming menu.
SERVICE PROGRAMMING
· ScA – Service coee alarm (Maintenance)
To change Service coee alarm, follow the steps below:
1. Enter the service programming and browse through the menu (see previous instructions).
2. When [ScA] is shown on the display, enter by pressing K5.
3. Select with K1 and K2 the Service coee alarm value. The counter can be adjusted in steps of
1000coees = [001]: From [000] = 0coees = Disabled, to [999] = 999000coees.
4. Accept and save setting by pressing K5. You are back in the service programming menu.
· tU – Temperature units
To change the Temperature units, follow the steps below:
1. Enter the service programming and browse through the menu (see previous instructions).
2. When [tU] is shown on the display, enter by pressing K5.
3. Select with K1 and K2 the Temperature units between: [c] Celsius; [F] Fahrenheit.
4. Accept and save setting by pressing K5. You are back in the service programming menu.
· SkP – Ski - Skd – PID parameters kP, Ki & kd
To change the PID factors value, follow the steps below:
1. Enter the service programming and browse through the menu (see previous instructions).
2. When [SkP], [Ski] or [Skd] is shown on the display, enter by pressing K5.
3. Select with K1 and K2 the selected PID parameter value.
4. Accept and save setting by pressing K5. You are back in the service programming menu.

Related product manuals