Cressi NEPTO - Units - Setting Metric;Imperial Units of Measure; Changing Measurement Units

ENGLISH
25
UNITS - SETTING METRIC/IMPERIAL UNITS OF MEASURE
The NEPTO computer can make its calculations using either metric units (depths
expressed in meters and temperatures in °C), or Imperial units (feet and °F). To
change the units of measure, from the UNITS screen, press
SEL
until you hear
the confirmation beep.
Check the measurements set, and then press
ESC
to exit the function.
HISTORY (HIST) - DIVE HISTORY
The HIST screen shows the dive history, which cannot be reset. The first line
shows the total number of hours used diving, Hxxx. The second line show the
maximum depth reached over the life of the watch.
INFO - DIVE HISTORY MEMORY
The INFO screen provides system information:
The first line shows the serial number, Sn xxxxx.
The second line shows the firmware version, xxx, and the number of battery
changes by the user.
The watch comes from the factory with the battery change counter set at 00.
CHANGE UNITS
ESC
TO RETURN
SEL
TO CHANGE
(C°-m / F°-ft)
HISTORY
ESC
TO RETURN
MAX
DEPTH
HISTORY
HOURS
IN USE
INFO
FIRMWARE
VERSION
NUMBER
OF BATTERY
CHANGES
SERIAL
NUMBER