ENGLISH
30
WARNING: The NEPTO computer was made strictly for recreational use and
not for professional dives, which require adequate training.
WARNING: After a freedive, the NEPTO watch will advise you not to fly for
24 hours.
NOTE: The manufacturer sets NEPTO to MODE SET (MODE-S) FREE at the
factory.
NOTE: The depth indicator gives indications between 0 – 120 m.
USE OF THE COMPUTER WITH POOR VISIBILITY
If at any time during the dive poor light conditions make it difficult to read the
display, the diver can turn on the backlight function by pressing the LIGHT button.
The display’s backlight lasts for a few seconds, and then automatically switches
off. When the backlight is on, some dark patches may also appear on the display.
The patches are not a defect. They are caused by the use of a high-contrast
display.
CARE AND MAINTENANCE
Cressi NEPTO has been designed and manufactured to operate in de-
manding conditions with intensive diving use. You should remem-
ber that it is a precision instrument and deserves appropriate care. It is
good practice to avoid strong blows, shield it from excessive heat, al-
ways rinse it in fresh water after use, dry it carefully, and never put it away
wet. Avoid contact with heavy equipment such as tanks.
WARNING: Avoid contact between the computer and solvents or chemical
substances. Do not use compressed air to dry the computer. The button does
not need any particular maintenance; never grease it with oil or sprays of any
kind.
NOTE: When replacing the battery, check its housing; should any signs of
moisture be visible, please have the instrument checked by an authorized
service center. Should you notice any anomaly in its operation, do not use the
instrument to dive and have it checked by an authorized Cressi retailer.
To Next Page
Loading...
