Description: Scuba Preview Mode
Image on Top: Normal Display
Image at bottom: Large Display
To Access: Under Menu, press UP Button
/ DOWN Button to locate the cursor and
then press MODE Button once to select
Scuba Mode.
For more information, please check page
13 for Scuba Preview Mode.
Description: Nitrox Setting
To Access: Under Scuba Preview Mode,
press UP Button Or from SETTINGS,
press UP Button / DOWN Button to locate
the cursor at Nitrox and then press MODE
Button to select.
The Oxygen percentage value at the
bottom of the screen will start blinking.
Switch the option with UP Button / DOWN
Button, once the desired Nitrox option
appears, select it by pressing MODE
button once to accept the value. Dive
computer will recalculate the MOD and will
be presenting NDL values corresponding
with the EANx and PO2 values previously
set.
You may set the EANx range from 21% to
56%. For air diving calculations please
make sure dive computer is set at 21%.
WARNING:
Please make sure you have measured the
EANx gas of the cylinder you are about to
dive with and correctly input that value in
your computer. Before using NITROX, you
To Next Page
Loading...
