Crest Audio CR-4 - Freediving Surface Interval Alarm

29
1.6.2 Freediving Mode Settings
Description: Freediving Surface Interval
Alarm
To Access: Under Freediving Preview
Mode, press UP Button Or from
SETTINGS, press UP Button / DOWN
Button; until the cursor aligns with FSI-
ALM. Press MODE Button once.
One of the FSI-ALM options will be blinking
at the bottom. Press UP Button / DOWN
Button to select other options as needed.
Press MODE Button to accept your
selection. If you set the FSI-ALM on, when
you reach the preset time, the alarm will
activate.
F = Freediving
SI = Surface Interval
ALM = Alarm
Description: Freediving Time Alarm
Setting
To Access: Under Freediving Preview
Mode, press UP Button Or from
SETTINGS, press UP Button / DOWN
Button; until the cursor aligns with FTIME-
THD1 to FTIME – THD3. Press MODE
Button once.
One of the FTIME-THD1 options will be
blinking at the bottom. Press UP Button /
DOWN Button to select other options as
needed. Press MODE Button to accept
your selection. If you set the FTIME-ALM
on, when you reach the preset time, the
alarm will activate.
Default alarm options:
30 secs, 60 secs, 90 secs.
Freediving Time Alarm Setting range:
0 secs – 360 secs.