Remote Temperature/Humidity Sensor Crestron C2N-RTHS
Side Views
Industry Compliance
As of the date of manufacture, the C2N-RTHS has been tested and found
to comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Network Wiring
CAUTION: In order to ensure optimum performance over the full range
of your installation topology, Crestron Certified Wire, and only Crestron
Certified Wire, should be used. Failure to do so, may incur additional
charges if support is required to identify performance deficiencies as a
result of using improper wire.
CAUTION: Provide sufficient power to the system. Insufficient power
can lead to unpredictable results or damage to the equipment. Please use
the Crestron Power Calculator to help calculate how much power is
needed for the system. Refer to (http://www.crestron.com/calculators).
4 • Remote Temperature/Humidity Sensors Operations & Installation Guide – DOC. 6232A
To Next Page
Loading...
Need help?
General
