Crestron CEN-GW1 - DIN Rail Mount; Wall Mount

15 • CEN-GW1 and CENI-GW1 ProductManual— Doc. 9195A
l
This product must be installed by a qualified electrician.
DIN Rail Mount
To mount the CEN-GW1 to a DIN rail:
1. Hang the mounting bracket on the top of the DIN rail and press the bottom toward the
DIN rail until it snaps into place.
2. Insert the CEN-GW1 into the mounting bracket until it snaps into place.
3. Secure the CEN-GW1 to the mounting bracket. Insert a6-32x3/8in.screw into each side
of the mounting bracket and tighten using a Phillips screwdriver.
NOTE: Do not use the included screws to mount the bracket to the bottom of the
CEN-GW1. Doing so will prevent removal of the CEN-GW1 from the DIN rail.
Wall Mount
To mount the CEN-GW1 to a wall:
1. Secure the mounting bracket to a vertical, flat wall using screws that are appropriate for
the wall material (not included).
2. Insert the CEN-GW1 into the mounting bracket until it snaps into place.