37 • CEN-GW1 and CENI-GW1 Product Manual — Doc. 9195A
Operation
Use the ACQUIRE, RESET, and SETUP buttons to perform the following functions:
Acquire Devices
Crestron SG, infiNET EX, and ER devices communicate with a CEN-GW1 after they are acquired
by the gateway. A device can be acquired by only one gateway.
NOTES:
l
Prior to acquiring devices, assign the RF channel on the gateway using the Web UI or
the EasyConfig tool in Crestron Toolbox™ software. For details, refer to Radio Setup
(on page29)or Crestron Toolbox Help.
l
Before adding ER devices, set the RF channel on the device to match the channel
assigned to the gateway.
l
After turning on the CEN-GW1, wait 15 seconds before entering Acquire mode.
l
In an environment with multiple gateways, only one gateway should be in Acquire
mode at a time.
l
Enter Acquire mode on the gateway before entering Acquire mode on the device.
To Next Page
Loading...
