Crestron CEN-GW1 - Poe Connection; Separate Power and Ethernet Connections

17 • CEN-GW1 and CENI-GW1 Product Manual — Doc. 9195A
PoE Connection
Use a PoE switch (CEN-SW-POE-5 or CEN-SWPOE-16) or injector (PWE-4803RU) (all sold
separately) to provide power and Ethernet communications.
To connect using a PoE connection:
1. On the CEN-GW1, connect the CAT5e cable to the LAN PoE port.
2. On the PoE switch or injector, connect the other end of the CAT5e cable to a PoE port.
NOTE: Arrows denote internal pin assignments of the LAN PoE and LAN ports.
LAN PoEPinAssignment
LAN Pin Assignment
Pin Signal
1 Data Pair 1
2 Data Pair 1
3 Data Pair 2
4 +VDC
5 +VDC
6 DataPair 2
7 - VDC
8 - VDC
Pin Signal
1 Data Pair 1
2 Data Pair 1
3 Data Pair 2
4 No Connection
5 No Connection
6 Data Pair 2
7 No Connection
8 No Connection
Separate Power and Ethernet Connections
Use a wall-mount power pack (PW-2407WU, sold separately) to provide power and the CAT5e
cable for Ethernet communications.
To connect using separate power and Ethernet connections:
1. On the CEN-GW1, connect the power pack to the 24V0.75Aport.
2. On the CEN-GW1, connect the CAT5e cable to the LAN PoE port.
3. Connect the other end of the CAT5e cable to a LAN port on a network switch.