Crestron DM-RMC-SCALER-S - Page 31

Crestron DM-RMC-SCALER-S/S2 DigitalMedia 8G Fiber Receiver
Operations & Installation Guide – DOC. 7324B DigitalMedia 8G Fiber Receiver: DM-RMC-SCALER-S/S2  25
3. Use the Address Book in Crestron Toolbox to create an entry for the
DM receiver using the TCP connection type, and enter the IP address of the
DM receiver.
4. Display the “System Info” window of the DM receiver (click the
icon);
communications are confirmed when the device information is displayed.
USB Communication via DM Switcher
PC Running
Crestron Toolbox
DM SWITCHER
DM-RMC-SCALER-S
PC Running
Crestron Toolbox
DM SWITCHER
DM-RMC-SCALER-S2
DM 8G SM Fiber
DM 8G FiberUSB
USB
To establish USB communication between the PC and the DM switcher:
1. Use the Address Book in Crestron Toolbox to create an entry using the
expected communication protocol (USB). When multiple USB devices are
connected, identify the DM switcher by entering “DM-MD8X8”,
“DM-MD16X16”, or “DM-MD32X32” in the Model textbox, the unit’s
serial number in the Serial textbox, or the unit’s hostname in the Hostname
textbox. The hostname can be found in the “System Info” window in the
section marked Ethernet; however, communications must be established in
order to see this information in the “System Info” window.
2. Display the “System Info” window (click the
icon); communications
are confirmed when the device information is displayed.