Crestron DMPS3-4K-150-C User Manual

DO GUIDE
DMPS3-4K-150 -C
3-Series
®
DigitalMedia
TM
Presentation System 150
DO Mount the DMPS3-4K-150-C
Mount the DMPS3-4K-150-C into a standard 19-inch rack, onto a at surface, or under a table as appropriate for the installation.
Mounting into a Rack
The DMPS3-4K-150-C occupies 1U of rack space.
WARNING: To prevent bodily injury when mounting or servicing this unit in a rack, observe the following guidelines:
• When mounting this unit in a partially lled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.
NOTE: Observe the following guidelines when installing equipment in a rack:
• Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be
greater than room ambient temperature. Therefore, consideration should be given to installing the equipment in an environment compatible with the
maximum ambient temperature (Tma) specied by the manufacturer.
• Reduced Airow - Installation of the equipment in a rack should be such that the amount of airow required for safe operation of the equipment is not
compromised.
• Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to uneven mechanical
loading.
• Circuit Overloading - Consideration should be given to the connection of the equipment to the supply circuit and the effect that overloading of the
circuits might have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings should be used when
addressing this concern.
• Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be given to supply connections other
than direct connections to the branch circuit (e.g., use of power strips).
To mount the unit into a rack, use the two included rack ears and do the following:
1. Using a #1 or #2 Phillips screwdriver, remove the three cover screws closest to the front panel on the left or right side of the unit.
2. Position a rack ear so that its mounting holes align with the holes vacated in step 1.
3. Secure the ear to the unit using the three screws removed in step 1.
4. Repeat steps 1 through 3 to attach the remaining ear to the other side of the unit.
5. Secure the unit to the rack using two rack mounting screws (not included) for each rack ear.
Mounting onto a Flat Surface
To mount the unit onto a at surface or to stack the unit on top of other equipment, use the four rubber feet included with the unit.
Mounting under a Table
To mount the unit under a table, use the four included table mount brackets and do the following:
1. Using a #1 or #2 Phillips screwdriver, remove the two cover screws closest to the front panel on the left or right side of the unit.
2. Position a table mount bracket so that its mounting holes align with the holes vacated in step 1.
3. Secure the bracket to the unit using the two screws removed in step 1.
4. Repeat steps 1 through 3 to attach a bracket to each of the three remaining positions as shown in the illustration below.
5. Attach the four table mount brackets to the underside of the table using four mounting screws (not included).
DO Make Connections to the DMPS3-4K-150-C
Make connections to the front and rear panels of the DMPS3-4K-150-C as required for the application.
Making Connections to the Front Panel
Connect the COMPUTER port (USB Type B) to a USB Type A port on a PC (USB 2.0 A/B cable not included).
DO Check the Box
QUANTITY PRODUCT PART NUMBER
4 Rubber Feet 2002389
1 Power Cord, 3-Prong, 6 Feet 2001134
1 Crestron
®
STIRP IR Emitter Probe 2001137
2 Interface Connector, Plug, 3-Pin 2003575
2 Interface Connector, Plug, 4-Pin 2003576
2 Interface Connector, Plug, 5-Pin 2003577
2 Rack Ear 2032122
4 Bracket, Table Mount 2041951
1 Important Safety Instructions 2018589
Not included: Cables, rack mount screws, and table mount screws
PC Running
Crestron Toolbox™
COMPUTER
HW-R SW-R
PWR NET MSG
DM 4K PRESENTATION SYSTEM
DMPS3-4K-150-C
IR IN
VOLUME
VGAAUTO
1 2 3 4 1 2 3 4
INPUT SELECT
HDMI
1 2
DM

Crestron DMPS3-4K-150-C Specifications

General

Brand	Crestron
Model	DMPS3-4K-150-C
Category	Projector Accessories
Language	English