20
HD-MD-6X2/4X2/4X1-4K-E: 4K HDMI Switchers Supplemental Guide – DOC. 7761A
Configuring Device Settings
To configure device settings, do the following: On the main menu, select
.
The Device Status and Configuration submenu opens.
Device Status and Configuration Submenu
< Device >
Details
Available selections are as follows:
Details
Front Panel
Firmware Update
Restore
Items on the Device Status and Configuration submenu are listed in the following table.
Refer to the table for configuration guidelines.
Device Status and Configuration Submenu Guidelines
SUBMENU
ITEM
GUIDELINES
Details (Read Only) Display the following information about the switcher:
•
Specifies the serial number of the switcher
•
Specifies the firmware version of the switcher
Front Panel
Controls the information that appears on the OLED display or disables the
OLED display and all controls on the switcher. Select one of the following:
•
(Default setting) Allows the IP address of the switcher
to be shown on the OLED display
•
Allows the route for each output to be shown on
the OLED display
•
Disables the OLED display, navigation pad, push buttons, and
LEDs on the switcher. Although the front panel is set to
, the
device continues to function.
To enable the OLED display, navigation pad, push buttons, and
LEDs, press and hold the
push button for 3 seconds.
An asterisk precedes the current setting.
Firmware Update
When selected, a prompt appears asking for confirmation that the firmware be
updated. Select
or
. If
is selected and a USB mass storage device
is not inserted into the SERVICE port of the switcher, the
message appears on the OLED display. To update the firmware, insert a USB
mass storage device containing the updated firmware file into the SERVICE
port.
Restore
When selected, a prompt appears asking for confirmation that the default
settings be restored. Select
or
. If
is selected, the
message appears followed by the
message.
To Next Page
Loading...
