Crestron HD-PS402 - Upgrade the Firmware; Configure the Device; Connect to the Cloud

Upgrade the Firmware
Before using the device, upgrade the firmware. The latest firmware can
be downloaded from the HD-PS402 product page on the Crestron
website (www.crestron.com).
Configure the Device
Configure the device using the web interface. To access the web
interface, open a web browser and then go to the IP address of the
device.
NOTE: By default, the IP address of an HD-PS402 device is assigned by
a DHCP server on the network. If a DHCP server does not exist on the
network, the IP address defaults to a link-local address in the
169.254.xxx.xxx range. To display the IP address on the connected
display, press the SETUP button on the front panel of the device.
If no account has been created, create an account by entering a user
name and password. After an account is created, log in to the web
interface by entering the user name and password.
Connect to the Cloud
The XiOCloud®service allows supported devices across an enterprise to
be managed and configured from one central and secure location in the
cloud. Supported Crestron® devices are configured to connect to the
service out of the box.
Use of the service requires a registered XiOCloudaccount. To register
for an XiOCloudaccount, refer to
www.crestron.com/Support/Tools/Licensing-Registration/XiO-Cloud-
Registration-Room-Licenses.
To connect the device to the XiOCloudservice:
1. Record the MAC address and serial number that are labeled on the
shipping box or the device. The MAC address and serial number are
required to add the device to the XiOCloudservice.
NOTE:Ifthe device has multiple MAC addresses, use the MAC
address that is providing the primary connection back to the
network. For most devices, the Ethernet MAC address should be
used. However, if your device is connecting to the network over a
different protocol (such as Wi-Fi® communications), use the
MAC address for that protocol instead.
2. Log in to your XiOCloudaccount at portal.crestron.io.
3. Claim the device to the XiOCloudservice as described in the
XiOCloudUserGuide.
Select the device from the cloud interface to view its status and
settings. The device may now also be managed and assigned to a group
or room. For more information, refer to the XiOCloudUserGuide.
NOTE:ForXiOCloud accounts with room-based licenses, the device
must be added to a licensed room before its status and settings can be
viewed.
6
HD-PS402
QuickStart
4x2 4K60 4:4:4 HDR Presentation System