Crestron IV-CAMFL-N-W-1B - Installation; In the Box

Product Manual — Doc. 9321A IV-CAMFL-N-W-1B • 11
Installation
Use the following procedures to install the Falcon IV-CAMFL-N-W-1B camera.
NOTES: Observe the following points.
l
Check the source power before powering on the camera. The Falcon can be powered
via a 9W PoE switch or with 12VDC. Under or overpowering the camera will cause
damage and poor performance that may not be immediately visible. If using a PoE
switch, be sure the port is properly configured for 9W. If using DC power and
connecting to a network switch, be sure the port is not set for PoE.
l
Do not power the camera with PoE and a power supply at the same time. Doing so
may cause it to malfunction.
l
Do not operate the camera beyond the specified temperature and humidity limits.
Operating range of the camera is between 32°F - 104°F (0°C -40°C). Ambient
humidity should be less than 95%RH.
l
Do not remove any screws from the camera. There are no user-serviceable parts
inside. Contact Crestron's True Blue Support Team if the camera is damaged or
malfunctioning.
l
Do not aim the camera lens at the sun or extremely bright lights. Doing so can cause
damage to the image sensor.
l
Do not directly expose the camera to rain, water, or high moisture.
l
This camera is for indoor use only.
In the Box
Qty. Description
1 IV-CAMFL-N-W-1B, 1 Beyond Falcon™ Presenter Tracking Camera, ePTZ, 2x Digital Zoom,
NDI®|HX Compatible
Additional Items
1 12VDC 1A power adapter
1 Wall mount bracket
1 Mounting template
4 Mounting screws
4 Drywall anchors, plastic