Crestron IV-CAMFL-N-W-1B User Manual

30 • IV-CAMFL-N-W-1B ProductManual — Doc. 9321A
VISCA Commands
1BeyondPTZ cameras can be controlled using the VISCA protocol through IP connection. By
default, the port for IP control is set to 5500. For serial communication, make sure the baud rate
of the controller is set to 9600bps. Below is a comprehensive list of VISCA commands that can
be used to control the cameras.
Start/Stop Tracking
Command Command Packet Comments
Start tracking (Recall CAM_Memory 80) 8x 01 04 3F 02 50 FF Call Preset 80, camera addr x
Stop tracking (Recall CAM_Memory 81) 8x 01 04 3F 02 51 FF Call Preset 81, camera addr x
NOTE:These commands can only be used with 1Beyond AutoTracker, AutoFramer, Falcon,
Hawk, PTZ-IP12, and PTZ-IP20 cameras. Under no circumstances should you ever overwrite
presets 80 and 81 on these cameras. Once configured, the end user must not overwrite
presets 0 and 1 since these are used as references to adjust framing while tracking is active.
ACK / Completion Messages
Command Message Comments
ACK z04y FF
(y:Socket No.)
Returned when the command is accepted.
Completion z0 5y FF
(y:Socket No.)
Returned when the command has been executed.
Error Messages
Command Message Comments
Syntax Error z0 60 02 FF Returned when the command format is different or when a
command with illegal command parameters is accepted.
Command
Buffer Full
z0 60 03 FF Indicates that two sockets are already being used (executing
two commands) and the command could not be accepted
when received.
Command
Canceled
z0 6y 04 FF
(y:Socket No.)
Returned when a command which is being executed in a socket
specified by the cancel command is canceled. The completion
message for the command is not returned.

Crestron IV-CAMFL-N-W-1B Specifications

General

Brand	Crestron
Model	IV-CAMFL-N-W-1B
Category	Security Camera
Language	English