Crestron Mercury CCS-UC-1 - NETWORK; DEVICE

Configuration Guide – DOC. 8256A CCS-UC-1: Crestron Mercury with Skype for Business • 5
Crestron Mercury Configuration
Setup
The LAN port of the Crestron Mercury device needs to be connected to one POE+ port to
power it up and be connected to the network for reachability to SfB. The PoE+ switch that
is used should have the LLDP functionality enabled for the device to power up and be
completely functional. By default, the “poeplus” configuration is set to Off on the device.
Configure the Device
To configure the Crestron Mercury device, follow this procedure:
1. Access the web GUI for the device by using an http session with the device’s IP
address. The device IP address used in this example was 10.64.201.60
Crestron Mercury: Login to Web GUI
2. Click Sign In and log in to the device. For information on device administration,
refer to the CCS-UC-1 Supplemental Guide (Doc. 7844) at
www.crestron.com/manuals.