Crestron TSW-770 - Page 201

Product Manual — Doc. 8550E TSW-70 Series • 195
Device Pairing
Click Device Pairing to configure settings for pairing the touch screen to a CEN-ODT-C-POE. The
CEN-ODT-C-POE provides local occupancy reporting for supported room scheduling apps.
NOTE:Formore information on the occupancy sensor, refer to the CEN-ODT-C-POE
Supplemental Guide. For more information on configuring the occupancy source in the
Crestron scheduling application, refer to the Crestron Room Scheduling Panels Operations
Guide.
Settings Tab – Device Pairing
l
Device Model:Usethe drop-down menu to select POE Occ Sensor.
l
Pairing Retry Time (Min):Entera duration (in minutes) that must elapse before the CEN-
ODT-C-POE reattempts to pair to the touch screen.
l
Pairing Status:Reportswhether the CEN-ODT-C-POE is paired to the touch screen
(Online) or not (Offline).
Device IP Address/FQDN: Enter the IP address or fully qualified domain name of the CEN-
ODT-C-POE. This is required for device pairing.
Device Authentication: Enter authentication credentials for the CEN-ODT-C-POE (if
required):
o
Device Username: Enter a valid username used to access the device.
o
Device Password:Entera valid password used to access the device.