CrimeStopper CS-2000 - User Manual

CS-2000 Series II
REMOTE CONTROL ALARM SYSTEM
INSTALLATION & OPERATING INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS on your choice of a Gargoyle™ Remote Alarm System by Crimestopper Security
Products Inc. This booklet contains the information necessary for installing, using, and maintaining your alarm
system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the
Tech Support number below.
*IMPORTANT INFORMATION: Primary and Optional Features:
-PRIMARY: These are features that must be connected in order for the system to operate properly; i.e. the
Siren, L.E.D., +12V Power, Ground, Doorpin, Override/Program/Valet Button etc.
-OPTIONAL: These are features to be connected if desired or agreed upon by the installing dealer. These
features may also require additional parts and/or labor fees. Consult with your installer beforehand; i.e. Door
Locks, Flashing Lights, Starter disable, Hood/Trunk trigger, and Auxiliary Remote Outputs etc.
This device complies with FCC Rules part 15. Operation is subject to the following
two conditions: 1) This device may not cause interference, and (2) this device
must accept any interference that may be received, including interference that may
cause undesired operation. The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modification to this equipment. Such
modification could void the user's authority to operate the equipment.
TECH SUPPORT
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
REV. A 02.2003 S/W:

Summary

Alarm System Installation Safety

Critical Installation Cautions and Warnings

Covers essential safety precautions, recommended tools, and wiring practices for installation.

Wiring Guide: Core Connections

Door Trigger and Chassis Ground Wiring

Details wiring for negative/positive door triggers and system chassis ground connections.

Ignition, Auxiliary Outputs, and Triggers Wiring

Explains connections for ignition, remote outputs, and hood/trunk triggers.

Wiring Guide: Advanced Connections

Horn Pulse and Starter Disable Wiring

Parking Lights, Power Input, and Sensor Wiring

Remote Transmitter Setup

Transmitter Programming and Pairing Procedure

Step-by-step guide to program new remote transmitters to the alarm system.

System Configuration Options

Programming Options Chart Overview

Lists all configurable system options with descriptions and default settings.

Configurable Options: Features Part 1

Horn Chirps, Passive Arming, and Door Locks

Details options for horn output, passive arming modes, and door locking behavior.

Door Open Warnings and Active Re-Arming

Unlock Pulse and Carjack Protection Setup

Configurable Options: Features Part 2

Silent Arming and Parking Light Options

Trunk Pop Control and Carjack Settings

Custom Override Security Feature

Emergency Disarm Sequence Configuration

Alarm System Operation Guide (Part 1)

Arming, Disarming, and Panic Mode Operation

Carjack Protection Modes

Active Carjack Protection Explained

Details the Active Carjack feature, its activation, and reset procedure.

Passive and Full-Time Carjack Modes

Explains Passive and Full-Time Carjack modes, their activation, and reset procedures.

CrimeStopper CS-2000 Specifications

General

Brand	CrimeStopper
Model	CS-2000
Category	Car Alarm
Language	English