Crivit 307553 - Page 43

43 GB/IE/NI
Problem Solution
Empty LC display or no
response after putting
the battery in again
Remove battery. If re-
quired, guide a sharp
instrument (e.g. a screw-
driver) into the hole
labelled “RESET”. Insert
a 3 V battery into the
battery compartment in
such a way that the +
terminal points upwards.
Replace the battery
cap on the battery
compartment. The
microprocessor is reset
and restarted.
Speed or distance are
not displayed
Adjust magnet and
sensor correctly.
- Check that the battery
is inserted with the
poles arranged the
right way round.