Crivit 307553 - Connecting the bicycle computer to the sensor; Using the bicycle computer

33 GB/IE/NI
If you wish to change the basic settings,
please follow the steps outlined in the chapter
“Resetting the bicycle computer“ and reset all
basic settings.
Connecting the bicycle
computer to the sensor
Use the magnet
1
to trigger the sensor
6
,
the speed tendency
19
shows a curve to con-
firm successful connection. The bicycle com-
puter
8
is now ready to use. If the
connection breaks, please follow the steps in
the chapter “Troubleshooting“ and reset all
basic settings. You will then have to reestab-
lish the connection between the bicycle com-
puter
8
and the sensor
6
.
Using the bicycle computer
Note: The bicycle computer will automatically
switch to standby mode when it has not been used
for over 5 minutes. Pressing any button or vibrations
will reactivate the computer. The function indicator
will show the current mode