Headrest
Holding both shoulder straps of the four point harness in between the
holes for the headrest, slide the metal rods on the headrests into the
openings on the top of the driver’s and passenger’s seats. Be sure
that both metal pieces slide into the holes on the tops of the seats.
IMPORTANT:
Be sure that both shoulder straps on each side are in
between the metal rods of the headrest before assembling.
IMPORTANT: For the safety of the driver and passenger, do not
operate the CrossFire 150 if the headrests are broken or no longer
attached, please contact customer service to order a new headrest.
WARNING: Before attempting to operate this vehicle,
be sure to tighten all loose bolt connections. Do NOT attempt to
operate this vehicle with hand-tightened, or loose bolt connections.
Front Lights
To connect the front lights, locate the plastic connector on the wire
coming from the front lights mounted on the left-hand side of the
front bumper. Next, locate the plastic connector on the wire coming
from the kart located on the frame next to the front bumper mounts.
Connect these two plastic fittings.
Steering Wheel
The steering wheel is in a “shipping” position and will need to be
adjusted before attempting to operate this vehicle. Do NOT operate
this vehicle without adjusting the steering wheel out of the
“shipping” position. To adjust the steering wheel, locate the four
bolts holding the adjustable plate to the kart frame. Loosen these
bolts so that the plate will rotate and allow the steering wheel to be
placed in a safe operating position. It may be necessary to adjust the
steering wheel depending on the height of the driver. After the
steering wheel has been adjusted, tighten the bolts to prevent the
steering wheel from moving while the kart is being operated.
(See figures on the following page for proper adjustments)
23 24
To Next Page
Loading...