Unpacking Parts
The first step in preparing your CrossFire 150 for driving is
removing the parts from the shipping box. Your CrossFire 150
should resemble the picture below when the top and sides of the
box are removed. See Figure below.
Unpacking
1. Remove all loose parts and place in an open area where they are
easily accessible and will not be damaged. It may be necessary
to cut the zip ties to access all loose parts.
2. After all loose parts are removed, begin assembling the go-kart.
3. All loose parts are listed below. If you are missing any parts, or
require assistance in your assembly process please contact us at
1-877-855-0196 or www.tpg-info.com
4. Please refer to the parts list on the following page.
(1)
(1)
(2)
(1)
(1)
(2)
(1) Set
(1)
(2)
Side Supports
Front Bumper
Rear Support Tube
Front Support
Side Rails
Rear/Center Support
Gas Tank
Headrest
Tires
(4)
7
Pads (set)
To Next Page
Loading...