Brush Guard Padding
Before assembly, place the tubular pads in their proper locations.
The three pads needed for this step are long and have no writing on
them. Locate the two (2) Side rails and place a pad on each as shown
below. Locate the Rear/Center Support and place a pad on it as
shown below. Be sure that the pads are secure along their seam and
tied tightly into place. Place these parts back with the others after the
pads have been properly installed.
There are four locations on the frame of the go-kart that need to
have pads attached. For assembly, be sure to use the two pads with
the CrossFire writing and the two short pads. See figure below for
proper locations.
Be sure that the pads are secure along their seams and that they are
securely tied in place at each end.
Before First Ride
Filling The Battery
The following procedure should only be performed by an adult
utilizing extreme caution. While attempting this procedure,
individuals should wear rubber gloves, eye protection, and have
water available in case the electrolyte solution comes into contact
with skin or eyes. Children should not attempt to complete this
procedure, and should NOT be allowed near the area when
attempting to fill the battery. This procedure should be completed
first so that the battery is charged when the kart assembly is complete
WARNING: POISON - CAUSES SEVERE BURNS
Contains sulfuric acid. Avoid contact with skin, eyes, and clothing.
To prevent accidents, rinse the empty electrolyte solution container
with water after use.
- If solution comes in contact with the skin, flush the area with
water.
- If solution is swallowed contact a physician immediately.
- If solution comes in contact with the eyes flush with water for
fifteen minutes. Get immediate medical attention.
KEEP OUT OF REACH OF CHILDREN
Procedure
- This procedure should be performed in a location out of reach of
children and animals.
- Remove the battery and the electrolyte solution from the shipping
crate. (See figures on page 12 to assist with this process)
- Place the battery on a level surface and remove the metallic sealing
from the top.
- Holding the electrolyte container upside down so the sealed
openings are facing the ground, align each sealed opening of the
bottles with the corresponding openings on top of the battery
terminal.
- Strongly push the electrolyte container into the openings of the
battery terminal so that the all of the seals on the electrolyte
container break, allowing electrolyte solution to flow into the
battery. Do NOT attempt to puncture the electrolyte container
unless the six sealed openings are properly aligned with the six
openings on the top of the battery terminal.
(x2)
9 10
To Next Page
Loading...