- Air bubbles will begin rising from each opening of the electrolyte
solution when they are punctured.
- If air bubbles are not rising in each individual tube, tap the top side
of the electrolyte bottles.
- Leave the electrolyte bottles in their draining position until all of
the electrolyte solution has drained. Do NOT attempt to remove
the electrolyte bottles while they are draining.
- Do NOT attempt to puncture or cut any part of the electrolyte
container.
- Do NOT allow children near the battery at any point during the
installation process.
- When the electrolyte solution has finished draining, pull the bottles
gently from the top of the battery terminal and properly discard in a
location out of reach of children or animals.
- The battery needs to sit for Thirty (30) minutes before charging.
Letting the battery sit will allow the electrolyte to penetrate the
plates and provide a longer battery life as well as better battery
performance.
- After sitting for thirty (30) minutes, the battery is ready for
charging.
Place the cap strip loosely over the holes in the top of the battery.
Do NOT push the caps all the way into the holes.
- After the battery has been sitting for thirty minutes, push the caps
firmly into place in the holes. This will seal the battery. Do NOT
attempt to remove the caps after sealing the battery.
11
12
1
2
3
4
5 6
7
8
To Next Page
Loading...