Gas Pedal
The pedal should not stick when applied or released. The pedal
should also return to the original position when released. If the pedal
sticks or hangs, please contact a customer service representative.
Loose Parts
Check the go-kart for any loose bolts, loose components, or leaks.
Any of these problems could affect the performance of the vehicle.
Headlights
Headlights should be checked to ensure that they are functioning
properly.
IMPORTANT: Headlights are not intended for night time operation.
Do NOT drive the go-kart at night.
Stop Engine Switch
With the engine running, flip the engine stop button to the stop
position. Make sure that the engine stops. Before attempting to start
the go-kart again, flip the button to the on position. Do NOT operate
the go-kart if engine stop switch does not work properly.
No Drugs Or Alcohol
It is not safe to operate the CrossFire 150 while under the influence
of alcohol or any type of drug. Choosing to operate this vehicle un-
der these conditions may result in serious injury to the driver and/or
passenger. If you have any questions about prescription medication,
please contact your physician.
WARNING: Operating this vehicle after consuming
alcohol or drugs can seriously impair your judgment, cause you to
react more slowly, affect your balance and perception, and could
result in serious injury or death. Never consume alcohol or drugs
while operating this vehicle.
WARNING: The exhaust system on this vehicle is
extremely hot while riding and immediately following operation.
Touching the exhaust system during or after operation could result
in severe burns. After use, park vehicle out of reach of children and
by-standers.
Driving
WA
RNING: Do not operate this vehicle without first
reading this manual. To ensure a safe riding experience, familiarize
yourself with all of the controls necessary to operate this unit. Before
attempting to start the engine, be sure that the riders are seated
properly with his/her safety harness securely fastened.
WARNING: If there is not a passenger riding in the
CrossFire 150, be sure that the passenger safety harness is properly
buckled. Buckling the passenger’s seat belt without a passenger
riding will keep the seat belt from getting caught in moving go-kart
components.
Stop Engine Switch
It is important to perform a test on the stop engine switch before
riding. With the engine running, switch the engine stop switch to the
off position “O”. The engine should shut off. To restart the vehicle,
place the switch in the run position”|”. If the engine does not shut off
during the test, Do NOT operate this vehicle and contact customer
service immediately. (Note the above symbols before operation)
Safety Harness
Do NOT operate or ride in this vehicle without properly wearing the
seat belts. The CrossFire 150 has (2) harnesses, (1) for the driver and
(1) for the passenger. Do NOT allow anyone to operate or ride in
this vehicle without being properly seated with their harness securely
fastened and properly adjusted. This vehicle seats (2) people, (1)
driver and (1) passenger.
RUN
OFF
29 30
To Next Page
Loading...