Crossfire 150 - Starting the Engine and Passenger Capacity

To connect the harness, properly sit in the seat and place each arm
through the shoulder strap on the corresponding side. After
shoulder straps are in place, buckle the lap belt and tighten by pulling
the loose ends away from the buckle. Proceed to tighten the shoulder
straps by pulling the loose ends towards the bottom of the go-kart.
Accelerator
The foot pedal on the RIGHT side is the accelerator pedal and
controls the speed of the go-kart. The engine utilizes an automatic
transmission and requires NO manual clutch or changing of gears.
Brake
The foot pedal on the LEFT side is the brake pedal and controls the
slowing/stopping of the go-kart. Applying pressure to this pedal
will slow the vehicle. If the brakes are not functioning properly, do
NOT attempt to drive this vehicle and immediately contact customer
service. When applying brakes, release the accelerator.
BRAKE
ACCELERATOR
Starting The Engine
Place the engine stop switch in the Run position “O”. While
depressing the brake pedal, insert the key into the ignition. With
foot still depressing the brake pedal, turn the key clockwise until the
engine starts. After the engine starts, release the key.
IMPORTANT: Do NOT hold the key in the turned position for more
than 5-7 seconds at a time. Doing so may damage the ignition.
Allow 10-20 second breaks between starting attempts.
IMPORTANT: Do NOT attempt to pump the accelerator while
starting the engine. The engine has an automatic choke and does not
require pumping of the accelerator.
NOTE: The engine will run at high RPM’s until it warms up. This
process should take between 3-5 minutes.
NOTE: The go-kart will NOT start unless the foot brake is engaged.
WARNING: Prior to starting the engine, check the
throttle assembly to ensure that when the pedal is pushed all the way
forward the assembly is working smoothly and returns to idle when
released. Do NOT operate if pedal or engine throttle linkage fail to
return to idle. If you are unable to correct the problem through
lubrication, adjustment, or replacement of worn parts, contact our
customer service center for assistance.
Passengers
The CrossFire 150 is intended to carry (1) driver and (1) passenger.
The combined weight of the driver and passenger should not exceed
180 kilograms or 400 pounds. Exceeding this weight limit may
create hazardous driving/riding conditions.
31 32