To Next PageTo Next Page
Need help?Do you have a question about the Crown CE Series and is the answer not in the manual?
General| Frequency Response | 20 Hz - 20 kHz ±0.5 dB |
|---|---|
| Signal to Noise Ratio | >100 dB (A-weighted) |
| Channels | 2 |
| Input Impedance | 20 kOhms balanced, 10 kOhms unbalanced |
| Protection | Short circuit, thermal, and DC fault protection |
Covers various warnings and cautions for safe operation and preventing electrical shock.
Advises on placement of sensitive equipment due to the amplifier's magnetic field.
Provides regulatory information regarding FCC rules for the device.
Explains the meaning of warning symbols used in the manual.
Lists the Electromagnetic Compatibility standards the product conforms to.
Lists the safety standards the product conforms to.
Highlights key features of the Crown CE Series amplifiers.
Provides guidance on effectively using the operation manual.
Instructions for unpacking the amplifier and checking for transit damage.
Guidance on rack mounting, stacking, and general installation.
Details on maintaining adequate airflow for amplifier cooling.
Explains options for balanced/unbalanced wiring and connector types.
Details on selecting speaker wire gauge and connector types.
Instructions for wiring the amplifier in stereo mode.
Methods for feeding the same signal to both amplifier channels.
Instructions for wiring and operating the amplifier in bridge-mono mode.
Details on selecting the correct input sensitivity for optimal performance.
Instructions for safely connecting the amplifier to the AC power source.
Step-by-step guide for the initial power-up sequence.
Important precautions to ensure safe and optimal amplifier operation.
Identifies controls and indicators on the front panel.
Identifies connectors and controls on the rear panel.
Detailed explanation of front panel controls and indicators.
Detailed explanation of rear panel controls and connectors.
Details the various protection systems built into the amplifier.
Explains Bias Servo, Fault, RF Protection, Drive Protection, and Compression.
Introduces optional SST modules for enhanced audio system capabilities.
Describes the SST-SBSC and custom cinema variants.
Describes the SST-4622 and SST-3632 cinema crossover networks.
Explains how to remotely monitor amplifier fault status using the Fault jack.
Details optional accessories like handles and adapters.
Information on optional barrier block and binding post output connectors.
Describes tamper-resistant hole plugs for level controls.
Details the optional 0.775 V input sensitivity setting.
Explains the signal flow through the amplifier's internal stages.
Describes the output stages, protection mechanisms, and thermal management.
Details the fault monitoring system and power supply components.
Visual representation of the amplifier's internal signal processing.
Troubleshoots problems related to the power indicator being off.
Identifies causes and solutions for distorted audio output.
Addresses problems with no input signal or input signal but no sound.
Troubleshoots flashing fault indicators and their potential causes.
Provides minimum guaranteed power ratings for various impedances.
Details frequency response, THD, IMD, damping factor, and crosstalk.
Includes voltage gain, load impedance, dimensions, and weights.
Information on obtaining service from authorized centers globally.
Details on obtaining service at authorized centers or the factory.
Instructions for returning units for factory service and shipping.
Outlines the terms, duration, and exclusions of the product warranty.
Steps to follow for requesting and receiving warranty service.
Covers disclaimers of damages and purchaser's legal rights.
