Crown DC-300A - Stereo Specifications

1.2 SPECIFICATIONS
1.2.1 STEREO SPECIFICATIONS
Output
Power
155
watts
per
channel
minimum
RMS
(both
channels
oper-
Frequency Response
1KHz Power
Harmonic Distortion
1.M. Distortion
(6OHz-7KHz 4:1)
Slewing Rate
Damping Factor
Output Impedance
Load Impedance
Voltage Gain
Input Sensitivity
Output Signal
ating)
into
an
8
ohm
load
over
a
bandwidth
of
1Hz-20KHzat
a
rated
RMS
sum
total
harmonic
distortion
of
0.05%
of
the
fundamental
output
voltage.
*0.1dB DC-20KHz at 1 watt into 8 ohms; +1dB DC-100KHz.
180
watts
RMS
into
8
ohms,
per
channel,
both
channels
operating,
0.1%
total
harmonic
distortion.
Less
than
0.001%
from
20Hz-400Hz,
and
increasing
linearly
to
0.05%
at
2OKHz
at
150
watts
RMS
per
channel
into
8
ohms.
Less
than
0.05%
from
0.01
watts
to
0.25
watts
and
less
than
0.01%
from
0.25
watts
to
150
watts
into
8
ohms,
per
channel.
8 volts per microsecond (slewing rate is the maximum value of the first derivative of the output
signal, or the maximum slope of the output signal).
Greater than 750, DC-400Hz into 8 ohms.
Less than 7 milliohms in series with less than 3. microhenries.
Rated
for
8
ohm
usage;
safely
drives
any
load
including
completely
reactive
loads.
20.642%
or
26.3+0.2dB
at
maximum
gain.
1.75 volts +2% for 150 watts into 8 ohms.
Unbalanced, dual channel.