INSTALLATION & OPERATION MANUAL 10068 REV 7 (05/21)
PAGE
10
OF 28
C
WARNING
Disconnect the power supply to the appliance before cleaning or servicing.
the kettle has cooled enough to touch it.
1. Rinse the inside of the kettle thoroughly and drain to remove any food particles.
2. Using a nylon brush, clean the kettle with a mild detergent and water. Never use steel wool or scouring powder as it
will scratch stainless steel. Plain steel wool can leave small pieces of steel which can rust.
depending on model, to allow the detergent and water solution to drain.
WARNING
Never spray water into electric controls or components!
CAUTION
Do not use cleaning agents that are corrosive.
WARNING
The equipment and its parts are hot. Use care when operating, cleaning and servicing.
WARNING
If you are cleaning a valve that is assembled to a kettle, be sure the kettle is completely empty of any product.
D-O V C
2. Replace the valve stem assembly and turn the hex nut until snug. Rinse the kettle with clean warm water.
C
NOTICE
rubber to pull away from stem and permanently damage it. This is not covered under warranty.
To Next Page
Loading...
