INSTALLATION & OPERATION MANUAL 10068 REV 7 (05/21)
PAGE
6
OF 28
U
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
Immediately after unpacking the steamer, check for possible shipping damage. If the steamer is found to be damaged,
save the packaging material and contact the carrier within 15 days of delivery.
Prior to installation, verify that the type of gas supply (natural or propane) and electrical service agree with the
and equipment requirements do not agree, contact your dealer immediately.
I
INSTALLATION
1. The kettle must be installed in accordance with:
1. State and/or local codes.
2. In the USA, the National Electrical code, ANSI/NFPA-70 (latest edition). In Canada, the Canadian Electrical
Code, Part 1, CSA Standard C22.1 (latest edition).
2. Set the kettle in the installation location.
side-to-side and front to back. On EP models use shims to level kettle.
pedestal base.
devices to accommodate 5/16” size lag bolts (not supplied).
7. Bolt down kettle and seal with Silastic or other equivalent sealing compound. Sealant must be applied not only to bolt
excess sealant immediately.
WARNING
Disconnect the electrical power supply and place a tag at the disconnect switch to indicate you are
working on the circuit. Disconnect the electrical power supply and place a tag at the disconnect
switch to indicate you are working on the circuit.
To Next Page
Loading...