Crown LPS-2500 - Wiring - Bridge-Mono Mode; Bridge-Mono Wiring with Speakon Connectors; Bridge-Mono Wiring with Binding Posts

LPS Series Power Amplifiers
Operation Manual
page 6
Wiring
BRIDGE-MONO WIRING USING THE SPEAKON
®
CONNECTORS
Bridge-mono mode doubles the output power of the amplifier.
1. See Figure 5. On the back panel, set the Output Mode Switch to BRIDGE.
2. Wire the speaker to the Speakon
®
connector as shown.
3. Only the Channel 1 Volume Control works in Bridge-mono mode.
BRIDGE-MONO WIRING USING THE BINDING POST CONNECTORS
Bridge-mono mode doubles the output power of the amplifier.
1. See Figure 6. On the back panel, set the Output Mode Switch to BRIDGE.
2. Wire the speaker to the Binding Post connectors as shown.
3. Only the Channel 1 Volume Control works in Bridge-mono mode.
Figure 6. Bridge-Mono Wiring With Binding Post Connectors
Figure 5. Bridge-Mono Wiring With Speakon
®
Connectors
2 +
1
3
–
Input signal
2 +
1
3
–
Input signal