Macro-Tech 2400 Amplifier Service Manual
18
Parts List (Non-Module)
Output Assembly (cont.)
CPN ITEM QTY (ONE PER CHANNEL)
M21322J8 Heat Sink with Fins 2
C 8573-5 2SA1186 PNP Driver Transistor 2
C 8574-3 2SC2837 NPN Driver Transistor 2
D 7665-9 T03P Mounting Clip 2
D 7666-7 T03P Bracket 2
Back Panel Assembly
CPN ITEM QTY
D 7975-2 Power Cord, 12/3 SO/W-A 20A U.S. Models) 1
A10793-0503G Power Cord (European Models) 1
M44018-6 PIP-FX 1
A10086-10410 Screw, 4-40 x .62 2
A10086-11008 Screw, 10-32 x .5 1
A10094-2 Lockwasher, #4 Internal Star 2
A10095-4 Lockwasher, #10 Internal Star 1
A10100-7 Aluminium Spacer, .250OD x .140ID x .312L 2
A10102-8 Nut, 10-32 Hex 1
C 4508-5 IC Socket, 16 Pin 1
C 6821-0 Edge Card Connector, 22 Contact 1
C 7500-9 #10 Flanged Spade 1
C 7705-4 Flat Cable Clamp 1
C 8812-7 5.5" Cable Tie 2
C10060-9 Header, 5 Pin R Angle Locking 1
C10184-7 Dual Binding Post 2
F11160-3 Strain Relief, Pwr Cord (U.S. Models) 1
C10187-0 Strain Relief, Pwr Cord (European Models) 1
F12672-6 Back Panel 1
P10286-6 Board, PIP Interconnect 1
Chassis Front Assembly
CPN ITEM QTY
A10086-10824 Screw, 8-32 x 1.50 RDHD PH (for handles) 4
C10258-9 Screw, 6-32 x .75 FLTHD 2
D 6013-3 Pushbutton, .75 Beaded 1
D 8048J6 Handle 2
D 8049J4 Panel Cap 2
F12647-8 Panel Cap Spacer 2
D 8052J8 End Cap 2
A10101-12 Spacer, #8 x 5/16OD x 1/4L 2
A10101-5 Nylon Washer, .5 x .136 x .02 2
A10103-10816 Screw, #8 x 1.00 Flat HD 2
A10173-1 Clip, Filter Grille 2
B 5796-6 Velcro Tape, 1/2 x 1/4 8
D 7696-4 Filter, FR Foam .53 x 16.7 2
D 8752-4 Grille Extrusion 1
Note:Note:
Note:Note:
Note: Old style grills with the one piece filter behind the grill are no longer available. If an old amplifer needs
a new grill, the only option is to convert it to the new style by ordering part number M46504-3, which includes
the bottom cover. New grills will not fit onto old bottom covers.
To Next Page
Loading...
Need help?
General