Macro-Tech 2400 Amplifier Service Manual
7
Voltage Conversion
The 120 Volt 60 Hz version, sold in the United States,
is not voltage selectable. It does not have voltage
selection boards. This version is to be used only with
120 Volts, 60Hz.
All other versions of the Macro Tech 2400 use voltage
selection boards. The following chart indicates which
jumpers are used for different voltages. Note that the
fuses and transmotor may need to be changed to
accommodate different voltages. Versions with the
voltage selection boards may be used at 50 or 60 Hz.
Jumpers
Circuit Breakers
CB100/CB200
Fuse
F1
Transmotor
TF1
VOLTAGE SELECTION BOARD
200V
120V
100V
240V
220V/230V
ORG—B
B—E
BLU—F
C—F
ORG—A
A—D
BLU—F
C—F
ORG—B
C—E
BLU—F
ORG—B
C—D
BLU—F
ORG—A
C—D
BLU—F
C10169-8
15 Amp
A10285-10
1 Amp
H42999-5
H42929-2
A10285-7
.5 Amp
C10171-4
8 Amp
H42928-4
To Next Page
Loading...
