Crown PIP-LITE - Page 6

Networked PIP Series
page 6
Reference Manual
Table of Contents (continued)
5.2.5 Thermal Headroom Level Monitor ............................ 29
5.2.6 Power/Standby Control ............................................. 29
5.2.7 Signal Mute .............................................................. 29
5.2.8 Polarity Inverter ....................................................... 30
5.2.9 Input Signal Fader .................................................... 30
5.2.10 Dynamic Gain Monitors (Ghost Faders) .................. 30
5.2.11 Amplifier Information .............................................. 30
5.2.12 User and Channel Labels ........................................ 30
5.2.13 Amplifier Mode ....................................................... 30
5.2.14 Amplifier Output Mode ........................................... 30
5.2.15 Line Voltage Monitor .............................................. 30
5.2.16 Error Reporting ....................................................... 30
5.2.17 Auto Standby .......................................................... 31
5.2.18 Input Signal Compressor/Limiter ............................ 32
5.2.19 Peak Voltage Limiter ............................................... 32
5.2.20 Average Power Limiter ............................................ 33
5.2.21 Clip Eliminator ........................................................ 33
5.2.22 Thermal Limiter ...................................................... 33
5.2.23 Limiter Tie .............................................................. 33
5.2.24 Load Supervision ................................................... 34
5.2.25 Typical Load Characteristics.................................... 35
5.3 PIP-USP3 and PIP-USP3/CN Features.............................. 36
5.3.1 Input Signal Router .................................................... 36
5.3.2 Filters ....................................................................... 36
5.3.3 Delay .......................................................................... 36
5.3.4 Noise Generator ......................................................... 37
5.3.5 Sine-wave Generator .................................................. 37
5.3.6 SLM (System and Load Monitoring)
Tab of the Control Panel ............................................. 37
5.4 PIP-USP3/CN Features...................................................... 42
5.4.1 Input Signal Router .................................................... 42
5.5 CobraNet (PIP-USP3/CN only)......................................... 42
5.5.1 CobraNet Module Parameters ................................... 42
5.5.2 CobraNet Input Routing ............................................ 43
5.5.3 CobraNet Output Routing .......................................... 44