18
ACCELERATOR PEDAL
The accelerator pedal is the pedal on the right, with the word GO
molded into it (Figure 17). The operation of the accelerator pedal
differs from that of an automobile. When the key switch is in the ON
position, and the Forward/Reverse handle is in either the
FORWARD or REVERSE position, pressing the accelerator pedal
will automatically release the park brake and start the vehicle
moving in the direction selected (forward or reverse). As the
accelerator pedal is pressed, speed will increase until full speed is
reached. When the accelerator is released, power will be cut off and
the motor will stop running
BRAKE PEDAL
The brake pedal is the large pedal on the left with the word STOP molded into it. To slow or stop the vehicle, press the brake
pedal with your foot (Figure 18).
PARK BRAKE PEDAL
The park brake pedal is the small raised portion in the upper left corner of the brake pedal. It has the word PARK molded into
it. To set the park brake, press the brake pedal firmly and tilt the park brake portion of the pedal forward with your foot
(Figure 19). See following WARNING and NOTE.
To Next Page
Loading...
