Crumar Seven User s Manual '
Sustain Pol.: Select N.C. for Normally Closed pedals, and N.O. for Normally Open pedals. This parameter can also be changed by
pressing and holding for 3 seconds the BANK button on the instrument panel.
Volume Type: this is normally set to “From Presets”, so that each time a new Preset is recalled, the volume knob is set to the value
stored into the preset. If you need to use the volume knob as a global volume adjustment that doesn't change each time a new
Preset is recalled, set this option to “Global”.
Memory Protect: this is normally set to OFF, but if you wish to lock your presets and avoid overwriting them accidentally, set this
option to ON.
10.2. PRESETS EXPORT / IMPORT.
The two buttons under the PRESETS section can be used to export or import a preset to/from the USB memory. When exporting a
preset, a file called “Seven_x-y.bin” is created, where x is the bank number and y is the preset number. This file can be renamed by the
user, but the extension .bin must be kept. When importing a preset, this will be imported and immediately activated, but doesn't
overwrite any existing preset until a preset store is performed by selecting the desired bank and the pressing and holding the desired
preset number until the LED animation confirms the write operation.
10.3. WAVETABLE EXPANSIONS.
The two buttons under the WAVETABLE EXPANSIONS section are used to install a wavetable expansion whenever this is released by
Crumar, or uninstall a previously installed expansion. Please follow the installation instructions provided with the expansion. When the
INSTALL NEW button is clicked, a pop-up window appears in order to select the expansion file from the USB drive. Here you can also
check the available storage memory.
Crumar Seven User's Manual - Page 23
To Next Page
Loading...
