Locate Water Dispenser
1. Place the water cooler on a flat level surface in a cool shaded location near a grounded wall outlet.
2. Position water dispenser so that the back of the unit is a minimum of 4 inches / 10 cm away from the wall
to ensure proper ventilation (Figure 1).
Install Water Bottle
(1) Open Dispenser door (Figure 2). (slide door upwards to allow access to bottle area)
(2) Place fresh bottle outside of the cabinet
(3) Clean the outside of new bottle with a cloth (Figure 3)
(4) Remove bottle cap completely from the top of the bottle (Figure 4)
(5) Un-package and assemble the Bottle Adaptor assembly (located in the bottle storage area)
(6) Place the bottle adaptor probe into the bottle (Figure 5)
(7) Slide the bottle adaptor over the neck of the bottle and push down to secure (Figure 6)
(8) Push probe down until the tube hits the bottom of bottle (Figure 7)
(9) Slide bottle into cabinet (Figure 8) and close the door (slide door downwards to close)
THANK YOU FOR BUYING A CRYSTAL MOUNTAIN WATER COOLER!
GETTING STARTED
Figure 1
Figure 2 Figure 3 Figure 4
Figure 5 Figure 6 Figure 7 Figure 8
To Next Page
Loading...
