RS112 Rugged Server
MEMORY REMOVAL AND REPLACEMENT
Removing and Replacing the Memory
Contact Crystal Technical Support before performing a memory upgrade. Use only
Crystal- approved memory for upgrades.
Disconnect power source to prevent injury.
Do not force the DIMM. Forcing the DIMM may result in equipment damage. Check the
alignment and keying before installing.
For population order see the motherboard guide received or contact Technical Support.
Steps:
1.
Turn the unit OFF and disconnect the unit from the power source.
2.
Open up chassis cover (see Removing the Cover in the Chassis Access section on page
15).
3.
If removal is required, locate the memory card area and open both DIMM release levers
by placing one finger on each lever and pushing outward. See Figure 8 on next page.
4.
The DIMM will lightly pop out of the slot. Remove the old DIMM.
5.
Check the orientation or key when adding new DIMM.
6.
Press the DIMM into its slot evenly on both ends until it clicks into place. The DIMM
release levers will snap into place.
7.
The DIMM is properly seated when the release levers have fully engaged.
RS112 Rugged Server User Guide Page 21 of 26
To Next Page
Loading...