Crystal RS112 - Installing in an Equipment Rack

RS112 Rugged Server
INSTALLING THE PRODUCT IN AN EQUIPMENT RACK
Using Fixed Mounting Brackets
To install RS112 with fixed mounting brackets in an equipment rack, complete the
steps and see Figure 1 below:
1.
Line up eight holes on the sides of the rear mounting brackets with eight holes on the
sides of the RS112 chassis and secure to chassis with 16 (eight per side) 8-32 x 0
screws provided (see #2 in Figure 1).
It may not be possible to line up all holes. If more than three holes do not line up on
each side, please contact Technical Support.
2.
Line up four holes on the front mounting ears at the desired level on the front of the
equipment rack, and attach to the rack using four (two per side) 10-32 x 0 rack screws
provided (see #3 in Figure 1).
3.
Line up four holes on the rear mounting ears at the desired level on the rear of the
equipment rack, and attach to the rack using four (two per side) 10-32 x 0 rack screws
provided (see #4 in Figure 1).
3
RS112 Rugged Server User Guide Page 10 of 26
Table
2.
Fixed Mounting Brackets
Parts List
ITEM
DESCRIPTION
1
MOUNTING EAR, EXTENDED SLOT
2
SCREW,
8
-
32
X
82D
PHL
FH,
SS
3
SCREW,
PHIL
TRUSS
HEAD
10
-
32
X
0.75"
4
SCREW,
PHIL
TRUSS
HEAD
10
-
32
X
Figure 1. RS112 with Fixed Mounting Brackets
1
1
3
3
2
4
4
Not all chassis support
Fixed Mounts