Crystal RS112 - Page 13

RS112 Rugged Server
Using Crystal Slides
To install RS112 with Crystal Slides in an equipment rack, complete the following steps
and see Figure 2 below:
1.
Loosen adjuster screws.
2.
Line up the top and bottom holes on the front & rear mounting ears at the desired level
of the equipment rack, and attach to the rack using four (two per side) 10-32 x 0.50 rack
screws provided (see #1, #2 and #5 in Figure 2).
3.
Tighten adjuster screws.
4.
Line up the server side slots with the slides and gently push to install in the rack.
5.
To secure the server when transporting or when extension of server is not necessary,
screw two 10-32 x 0 screws into the middle hole of the front bracket ears (see #1 and
#4).
Table
3. Crystal
Slides Parts
List
ITEM
DESCRIPTION
1
FRONT
MOUNTING
EAR,
SLIDE
2
REAR
MOUNTING
EAR,
SLIDE
3
GUIDEBAR,
T
-
SLOT
SLIDE
4
SCREW,
PHIL
TRUSS
HEAD
10
-
32
X
5
SCREW,
PHIL
TRUSS
HEAD
10
-
32
X
6
SCREW,
8
-
32
X
FHD
82D,
SS
RS112 Rugged Server User Guide Page 11 of 26
Not all chassis support Crystal Slides
Figure 2. Crystal Slides