How to troubleshoot loss of water pressure in my CSI Water Filtration System?
If you're experiencing a loss of water pressure with your CSI Water Filtration System, the media might be fouled. Try cleaning the media and consider pretreatment to prevent future fouling. Also, check if the backwash setting is improper and backwash more frequently if needed.
What to do if my CSI Water Filtration System has poor water quality?
If your CSI Water Filtration System's water quality is poor, several factors could be the cause. First, ensure the bypass valve is closed. Check for channeling, which can be due to service flow being too slow or high, or media fouling. Also, ensure there's enough aeration in the water; you may need to program the valve to draw air more frequently or increase the number of minutes in the air draw cycle. Finally, clean the injection assembly and screen.
What to do if my CSI Water Filtration System fails to regenerate automatically?
If your CSI Water Filtration System isn't regenerating automatically, there are several potential causes. First, ensure the power supply is connected to a constant power source. If the power source is okay, check the control valve programming and reset the program settings if necessary. If problems persist, the power supply or drive motor might be defective and need replacement.
What to do if my CSI Water Filtration System is regenerating at the wrong time?
If your CSI Water Filtration System is regenerating at the wrong time, it might be due to the time of day being improperly set because of a power failure. Reset the time of day programming and consider installing a 9-volt battery. It could also be that the regeneration time is set improperly, so reset the regeneration time programming.
What to do if my CSI Water Filtration System has continuous flow to drain?
If your CSI Water Filtration System experiences continuous flow to drain, check for a jammed piston. If found, replace the piston and seals. Also, if the motor is unresponsive, replace it.
Covers location, electrical, plumbing, and site preparation for unit installation.
Step-by-step instructions for media installation and water supply connection.
Details power supply hookup and essential pre-operation checks for the system.
Instructions for adjusting time, backwash frequency, and regeneration time using the app.
Instructions for setting regeneration time, backwash cycle durations, and chlorine injection.
Step-by-step guide for replacing the powerhead, piston, seals, and spacers.
Guide to diagnosing and resolving common problems like poor water quality and pressure loss.
Explains the meaning of error codes (Err 2-6) and the process for their resolution.
General| Brand | CSI |
|---|---|
| Model | SK15 |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
