CTEK POWERSPORT User Manual

EN • 9
EN
RECOND LITHIUMNORMAL
ERROR
LAMP
MODE
BUTTON
NORMAL
BATTERY
PROGRAM
POWER
LAMP
RECOND
PROGRAM
LITHIUM*
BATTERY
PROGRAM
FULLY
CHARGED
OPERATING
INSTRUCTIONS
1. Read safety instructions
2. Connect the charger to the battery.
3. Connect the charger to the wall socket. The power lamp
will indicate that the mains cable is connected to the
wall socket. The error lamp will indicate if the battery
clamps are incorrectly connected. The reverse polarity
protection will ensure that the battery or charger will not
be damaged.
4. Press the MODE-button to select charging program.
Follow the display through the charging process.
The battery is fully charged when "CARE" is lit.
5. Stop charging at any time by disconnecting the mains
cable from the wall socket.
*) 12V lithium batteries (LiFePO
4
, Li-Fe, Li-iron, LFP)

CTEK POWERSPORT Specifications

General

Input Voltage	220–240VAC, 50–60Hz
Charging Current	0.8A
Back Current Drain	<1Ah/month
Ambient Temperature	-20°C to +50°C
Start Voltage	2.0V
Ripple	<4%
Protection Class	IP65
Battery Types	12V: Wet, MF, Ca/Ca, AGM, GEL
Dimensions	168 x 65 x 38 mm
Protection Features	Reverse polarity protection, Short circuit proof
Output Voltage	12V
Charging Modes	8-step charging program