Leddura 2Share
1514
Share, inspire, have fun!
With CTOUCH by your side.
ctouch.eu
Switch the CTOUCH interactive
display power on or off
Confirm or enter a sub-menu
or toggle between options
during menu operation
Home page of the CTOUCH
interactive display
Display or exit the setting
menu screen
Mute the sound
Freeze the current picture
Volume down
Display or exit input source
menu
Use Arrow buttons to navigate
in on-screen menu
Return to previous menu or exit
the on-screen menu
Turn off the picture on the
CTOUCH interactive diaplay and
listen to the program audio only
Volume up
Freeze the current picture
REMOTE CONTROL BASIC OPERATIONS
TURNING THE CTOUCH INTERACTIVE DISPLAY ON OR OFF
1. Plug the power cord into an AC power outlet.
2. Switch the Power Switch on, to turn the CTOUCH interactive display on.
3. The display is in standby mode now. Wait a moment until the power indicator lights up, then
press to turn on the CTOUCH interactive display.
Note! Be sure to wait for a few seconds before pressing button. If you promptly press the
CTOUCH interactive display may act wrongly or not respond at all.
4. Press button again to put the display in standby mode.
5. Switch the Power Switch off to cut off the power completely.
Note! If the CTOUCH display is on the VGA source and does not get any signal, it will go into
stand-by mode after two minutes. When the CTOUCH display is on others sources and
does not get any signal, it will go into stand-by mode after 10 minutes.
FIRST TIME INSTALLATION
When turning on the CTOUCH display for the first time, the below shown installation menu pages
will appear on the screen.
WIRED
Plug the LAN-cable into the LAN-port on the bottom or side of the CTOUCH display, to connect to
the internet.
Select the desired menu
language. Press START to go to
the next page.
Select your location and press
NEXT to go to the next page.
Select your required Energy
Saving Mode and press NEXT
to finish the installation.
To Next Page
Loading...
Need help?
General
