Operation
Turn On / Off The Camera
Switch the Mode Button to“Test/On”to turn on the camera.
Switch the Mode Button to “Off” to turn off the camera.
System Setup
Switch Mode Button to “Test”, then you can set the camera‘s
parameters as your need.
1. Press Video/Photo button to switch the two modes.
2. Press Menu button to open the setup menu.
3. Press Up/Down button to scan all menu. Then press OK button
to enter the options interface.
4. Press Up/Down button to scan all options. And press OK button
to confirm options.
5. Press Menu button again to turn back to last menu or exit the
setup menu.
Tips before running the camera
1. ♦Please make sure the SD card has been inserted
2. ♦Please install the batteries (both remote control and camera)
To Next Page
Loading...
Need help?
General