CTS HES-3106 Series User Manual

8
2. INSTALLATION
To properly install the Managed Switch, please follow the procedures listed
below. Procedures covered in this chapter are described below in separate
sections.
 Installation Requirements
 Unpacking the Managed Switch
 Installing the Managed Switch
 Powering on the Managed Switch
 Connecting the Managed Switch to the Network
2.1 Installation Requirements
Basic requirements for installation are as follows:
 Environmental conditions
 One power outlet
 Proper ventilation
 Proper isolation to electrical noise, radio, etc..
 UTP cables should not run in the same duct with power and
phone line cables
 Required SFP Transceivers or UTP cables
2.2 Checking the Package Contents
Unpack the package carefully and check the package contents. The package
should contain the following items:
 Items included in standard package:
 1 Managed Switch
 1 Documentation CD
 1 Power Adaptor
If any of the above items is found missing or damaged, please contact your local
sales representative for support or replacement.

CTS HES-3106 Series Specifications

General

Brand	CTS
Model	HES-3106 Series
Category	Switch
Language	English